Please choose the accessories and probe which are
approved or manufactured by the manufacturer, or else
it may damage the device.
Please don't measure this device with functional tester
for the device's related information.
When uploading, do keep the patient form touching the
USB port. The computer used when uploading must be
in accordance with EN60950. In addition, when the
data line connected to a computer, the medical
electrical systems should be in accordance with
IEC60601-1-1.
1.3 Attention
Keep the oximeter away from dust, vibration, corrosive
substances, explosive materials, high temperature and
moisture.
If the oximeter gets wet, please stop operating it.
When it is carried from cold environment to warm or
humid environment, please do not use it immediately.
DO NOT operate keys on front panel with sharp
materials.
High temperature or high pressure steam disinfection
of the oximeter is not permitted. Refer to User Manual
in the relative chapter (7.1)for instructions of cleaning
and disinfection.
To Next Page
Loading...
Need help?
General
