b) Data storage setting
This instrument has the ability to store 24 hours worth
of data. It can store the measured pulse rate and SpO
2
value accurately, transfer the data to the computer,
display the data and print reports.
a. On the main menu interface as shown in Figure
7, Click the button to select “Record”, then press the
button to choose whether store the data or not, choose
“on” to permit storing, choose “off ” to forbid storing.
b. If the data storage function is being turned on,
when return to the measuring interface, a flashing
yellow dot would appear on screen, which means the
device is in a state of storing.
c. In the state of storing, the device is on
measuring interface, the sign "Recording" would
appear on the screen in 30 seconds, and then the screen
will be automatically shut down, only a flashing
yellow dot appear on screen. If short press the button
at this moment, the sign "Recording" would appear on
the screen, and then the screen will be automatically
shut down again; if long press the button, the device
would return to the measuring interface.
d. If turning on the data storage function, the
former data storage will be automatically removed.
To Next Page
Loading...
Need help?
General
