‘Down’, then Click the button to select high limit (High) or
low limit (Low). Press the button and hold to adjust the
selected limit to the desired lower value and release the
button once the lower limit has been reached.
If the alarm function is on, the device will provide
medium-priority alarm signal when the data of SpO
2
or
pulse rate is beyond the limit. Intermittent alarm will
occur and the measuring value will be flashing.
Medium priority indicating that prompt operator
response is required.
b. Pulse sound indication setting
On the alarm setting interface as shown in Figure
7,Click the button to select “Psound”, then Press the
button to choose to have the Pulse Sound (heart beat)
alarm “on” or “off”.
c. The alarm state setting
On the alarm setting interface as shown in Figure
8,Click the button to select “Alarm”, then Press the
button to choose alarm on or off, press “ on” to turn on
the alarms and “ off” to turn off the alarms.
d. Exit the Alarm settings , the alarm direction setting ,
the SpO
2
or PR direction setting
Click the button to select “Exit”, then Press the button
to exit the Menu and return to the previous Menu .
To Next Page
Loading...
Need help?
General
