72
10.3 BP Measurement
The user can be set to three different types(adult, pediatric and newborn). Set it through the [USER TYPE] option in [SYS-
TEM SETUP] menu.
Note
When the patient is a newborn, please select the newborn mode and select the appropriate size of the cuff to
measure, otherwise it may cause harm to the patient.
1. Press [START/STOP] button to start measurement.
During measurement, please keep correct pose and quiet state, do not move.
If you want to abort the measurement
Press [START/STOP] button, the device will stop inating, and release the air from the cuff.
2. Conrm the Measurement Value
The measurement value can be stored automatically, using [memory function] (refer to Chapter11).
*Self-diagnosis and treatment using measured results may be dangerous. Follow the instructions of your physician.
Note
• Wait at least 4-5 minutes between measurements
When repeatedly measuring, the accurate blood pressure value may not be measured due to congestion in the arm.
Please measure after the blood ow is smooth.
• When some factors affect the measurement results in measurement process, error messages will appear on the screen,
you can obviate the malfunction and restart a measurement.
• The minimum value of the patient’s physiological signal is the minimum limit that the device can measure. The device
may obtain inaccurate measurement results when it is operated below the minimum amplitude or minimum value of the
patient’s physiological signal.
3. In the state of the physiological parameter over-limit prompt is not triggered, press any button to carry on the correspond-
ing button function; in audio prompt state, press any button (except [ON/OFF] button) to clear up the audio prompt.
4. Take off the cuff, press [ON/OFF] button to turn the device off.
ENGLISH
To Next Page
Loading...
Need help?
General
