Conti MC ULTIMA - Page 28

Edition 05/2021 - MC ULTIMA- Technical documentation - page 28
SACOME, CONFIDENTIAL Document, it is forbidden to duplicate or communicate this document without previous authorization.
10.6 Installation
10.6.1 1
st
installation: see detailed procedure in chapter 5
10.6.2 Pressure alignment
 This menu allows to adjust the value shown by digital manometer according to the value shown by
the mechanical manometer.
 Press on the button “Pressure Alignment”.
 The pump starts up.
 The display shows :
 Press the digit of the corrected value to highlight it:
 Press on + or – to change the value.