EasyManua.ls Logo

Continental Fireplaces Builder 36 Series - User Manual

Continental Fireplaces Builder 36 Series
144 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
FRENCH
PG. 73
W415-1848 / A / 03.11.19
ADD MANUAL TITLE
Wolf Steel Ltd., 24 Napoleon Rd., Barrie, ON, L4M 0G8 Canada / 103 Miller Drive, Crittenden, Kentucky, USA, 41030
Phone 1 (866) 820-8686 • www.continentalfi replaces.com • hearth@continentalfi replaces.com
CERTIFIED TO THE CANADIAN AND AMERICAN NATIONAL STANDARDS:
CSA 2.22 AND ANSI Z21.50 FOR VENTED DECORATIVE GAS APPLIANCES
INSTALLER:
Leave this manual with the appliance
CONSUMER:
Retain this manual for future reference
ADD PRODUCT CODE HERE (TRADE GOTHIC LT STD FONT)
NATURAL GAS MODELS:
PROPANE GAS MODELS:
Product Name / Code
(MUST use title from Price Book)
ADD ____ ILLUSTRATED
ADD PRODUCT IMAGE
CSA /
INTERTEK
LOGO
SAFETY INFORMATION
- Do not store or use gasoline or other
ammable vapors and liquids in the vicinity of
this or any other appliance.
- WHAT TO DO IF YOU SMELL GAS:
Do not try to light any appliance.
Do not touch any electrical switch; do not
use any phone in your building.
Immediately call your gas supplier from a
neighbour’s phone. Follow the gas
supplier’s instructions.
If you cannot reach your gas supplier, call
the fi re department.
- Installation and service must be performed
by a qualifi ed installer, service agency, or the
supplier.
This appliance may be installed in an aftermarket,
permanently located, manufactured home (USA
only) or mobile home, where not prohibited by
local codes.
This appliance is only for use with the type of gas
indicated on the rating plate. This appliance is
not convertible for use with other gases, unless
a certifi ed kit is used.
FIRE OR EXPLOSION HAZARD
Failure to follow safety warnings exactly
could result in serious injury, death, or
property damage.
WARNING
!
ENGLISH
$10.00
FOR INDOOR USE ONLY
IF INSTALLATION + OPERATION, ADD SERIAL
NUMBER LABEL HERE
IF SEPARATE MANUALS, ADD “PLACE
BARCODE LABEL ON THE OWNER’S MANUAL”
CB36NTR / CB36NTRE
CB36PTR / CB36PTRE
Builder Series 36
INSTALLATION AND
OPERATION MANUAL
B36 ILLUSTRATED
SAFETY BARRIER
f i r e - p a r t s . c o m

Table of Contents

Questions and Answers

  • J
    Jeffrey BarreraNov 22, 2025
    How to fix a pilot light that will not light on my Continental Fireplaces Indoor Fireplace?
    • W
      wmorganNov 22, 2025
      If the pilot light won't ignite on your Continental Fireplaces Indoor Fireplace, there are several things to check: * First, verify that the sensor wire and igniter wire are connected to the correct terminals on the module (not reversed). * Ensure there are no loose connections, electrical shorts, or grounding issues in the wiring. * Check the igniter spark gap, it should be 1/8” (3.2mm). * Confirm the transformer is installed and plugged into the module, with a voltage between 6.2 and 7.0 volts A.C. when the switch is ON. * If using a battery backup, check the batteries. * Remove and reinstall the wiring harness, verifying continuity of each wire. * Troubleshoot with a simple ON/OFF switch to rule out improper switch wiring. * Ensure the valve and pilot assemblies are pro...
  • R
    Richard GarciaAug 25, 2025
    What to do if Continental Fireplaces Builder 36 continues to spark and pilot lights, but main burner will not light?
    • J
      Jamie OrtizAug 26, 2025
      If your Continental Fireplaces Indoor Fireplace continues to spark and the pilot light is on, but the main burner won't light, check the following: * Verify all connections are tight and not grounding out to any metal, especially those from the pilot assembly. * Ensure the flame is engulfing the sensor rod to improve flame rectification. * Clean the sensor rod with a fine emery cloth or synthetic scrub pad to remove any accumulated contamination.
  • J
    Joseph StevensAug 27, 2025
    Why is the main burner flame blue, lazy, and transparent on my Continental Fireplaces Indoor Fireplace?
    • D
      dillonrachelAug 27, 2025
      If the main burner flame on your Continental Fireplaces Indoor Fireplace is blue, lazy, and transparent, check for a blockage in the vent and remove it. In extreme conditions, ice buildup may occur on the terminal and should be removed. Also, check the venting system parameters, such as the seal, length, and rise.
  • E
    Emily DixonAug 27, 2025
    What to do if I smell exhaust fumes and have headaches from my Continental Fireplaces Builder 36?
    • L
      lreeseAug 27, 2025
      If you smell exhaust fumes in the room or experience headaches when using your Continental Fireplaces Indoor Fireplace, check all seals on the appliance. Also, check if exhaust is re-entering through an open door or window.
  • R
    Rachel RobertsAug 29, 2025
    Why are the flames very aggressive on my Continental Fireplaces Builder 36?
    • D
      Daniel GoodwinAug 29, 2025
      If the flames on your Continental Fireplaces Indoor Fireplace are very aggressive, first check if the door is ajar and tighten the door clamps if applicable. If the venting action is too great, restrict the vent exit with a restrictor plate.
  • J
    Jeffrey IbarraSep 23, 2025
    Why is there no gas to the main burner on my Continental Fireplaces Indoor Fireplace?
    • D
      Dr. John NewmanSep 23, 2025
      If the pilot is burning, but there's no gas to the main burner, with the gas knob on ‘HI’ and the wall switch/thermostat on, for your Continental Fireplaces Indoor Fireplace, purge the gas line. Also, check if you are out of propane gas and fill the tank if necessary.
  • S
    samanthakingSep 16, 2025
    Why does the pilot go out when the gas knob is released on my Continental Fireplaces Builder 36 Indoor Fireplace?
    • L
      Linda JacksonSep 16, 2025
      If the pilot goes out when the gas knob is released on your Continental Fireplaces Indoor Fireplace, allow approximately 60 seconds for the thermocouple to cool.
  • T
    Thomas HernandezSep 18, 2025
    Why is there a white film forming on my Continental Fireplaces Builder 36?
    • E
      Emily BentonSep 18, 2025
      If you observe a white or grey film forming on your Continental Fireplaces Indoor Fireplace, this is likely sulphur from the fuel being deposited on the glass, logs, or combustion chamber surfaces. Clean the glass.
  • M
    Megan WebsterSep 8, 2025
    Why does the pilot light but stop sparking on my Continental Fireplaces Indoor Fireplace?
    • M
      Morgan RamirezSep 8, 2025
      If the pilot lights but stops sparking, or remains lit but the burner won't turn on in your Continental Fireplaces Indoor Fireplace, inspect all wires to ensure good, tight connections and that they are installed correctly. Inspect the wiring harness, ensuring it's tightly connected to the module and that all wires are in the right order.
  • B
    Bruce WuSep 5, 2025
    How to fix a pilot light that won't light on a Continental Fireplaces Builder 36 Indoor Fireplace?
    • S
      smithkevinSep 5, 2025
      If the pilot light won't ignite in your Continental Fireplaces Indoor Fireplace, check the wiring to ensure the sensor and igniter wires are correctly connected to the module. Verify there are no loose connections, electrical shorts, or grounding to metal objects. Ensure the igniter spark gap is 1/8” (3.2mm). Check the transformer is installed, plugged into the module, and has a voltage between 6.2 and 7.0 volts A.C. If using a battery backup, check the batteries. Remove and reinstall the wiring harness, verifying continuity of each wire. Ensure the valve and pilot assemblies are properly grounded to the metal chassis.

Continental Fireplaces Builder 36 Series Specifications

General IconGeneral
ModelBuilder 36 Series
CategoryIndoor Fireplace
VentingDirect Vent
Fuel TypeNatural Gas or Propane
Viewing Area36 inches

Related product manuals