Contour CoreBelt User Manual

26
Problem Possible Cause Solution
I am not feeling
anything
Gel Pad not directly against
your clean, dry skin
Make sure the plastic liner is removed from
yourgelpadelectrodeandplaceit(BLACK
SIDE) directly against your clean, dry skin.
Intensity level might not be
high enough
The intensity must be at least 15% before
you will feel anything.
Gel Pads may not be
properly positioned
Turn the M2 device off, remove the Core-
belt
™
and reposition as described in this
manual. Make sure the Gel Pads are below
your rib cage.
The Lead-Wire module is
not inserted correctly
Make sure the wires are securely attached
I pressed power
and the device
doesn't turn on
The batteries are inserted
improperly
Replace batteries in proper position as
shown on the set-up pages
The batteries are dead Replaceall4AAAbatteries
Never mix old and new batteries
Display is on but
there is no signal
The device is paused Press On/Off button
The Lead-Wire module is
not inserted correctly
Slide the Lead-Wire module onto groves
of the M2 device until you hear it click
into place
The Lead-wire(s) may not
be connected to the Gel
Pads
Turn the M2 device off and insert the
pin-end of the electronic module wire into
the wire from the Gel Pad
Gel pad electrodes are
not making contact with
your skin
Make sure the black side of the gel pad
electrode is making good contact wIth your
clean, dry skin
The battery
symbol is flashing
The batteries are low Replaceall4AAAbatteries.
Never mix old and new batteries
The contractions
are weak even
though the
intensity is high
The batteries are low Replaceall4AAAbatteries.
Never mix old and new batteries
The Gel Pads have
lost conductivity
Replace Gel Pads
The pads are positioned
improperly
Turn the M2 device off, remove the Core-
belt
™
and reposition as described in this
manual. Make sure the Gel Pads are below
your rib cage.
Troubleshooting
27
Problem Possible Cause Solution
Stimulation is
uncomfortable
The Gel Pads may
be worn out
Replace Gel Pads
Intensity level might be set
too high
Reduce the intensity level until your body
gets used to it.
Gel Pads may not
be properly positioned
Turn the M2 device off, remove the
Corebelt
™
and reposition as described in
this manual. Make sure the Gel Pads are
below your rib cage
Too many sessions in a row Leave at least six hours between
sessions
My muscles are
sore after using the
Contour CoreBelt
™
Intensity level might be set
too high
Reduce the intensity level
I feel tingling in
my legs
Gel Pads are located near a
nerve center
Move the Gel Pads slightly
I just bought the
Contour but I’m not
seeing results
Your diet plays a vital
role.Areyoufollowingthe
Contour diet plan?
Follow the eating plan in the Diet and
Exercise Guide
The intensity level might not
be set high enough
Increase the intensity level.
You should see results in 2-3 weeks

Contour CoreBelt Specifications

General

Brand	Contour
Model	CoreBelt
Category	Fitness Equipment
Language	English