CONTRASTECH Mars Series - Page 23

- 23 -
ExclusiveAccess
ControlAccess
Grants exclusive access to the
device to an application. No
other application can control or
monitor the device.
Grants control access to the
device to an application. No
other application can control the
device.
GevMCPHostPort
GevMCPHostPort
Controls the port to which the
device must send messages.
Setting this value to 0 closes the
message channel.
GevMCDA
GevMCDA
Controls the destination IP
address for the message
channel.
GevMCTT
GevMCTT
Provides the transmission
timeout value in milliseconds.
GevMCRC
GevMCRC
Controls the number of
retransmissions allowed when a
message channel message
times out.
GevStreamChannelSelector
GevStreamChannelSelector
Selects the stream channel to
control.
GevSCPInterfaceIndex
GevSCPInterfaceIndex
Index of the logical link to use.
GevSCPHostPort
GevSCPHostPort
Controls the port of the selected
channel to which a GVSP
transmitter must send data
stream or the port from which a
GVSP receiver may receive data
stream. Setting this value to 0
closes the stream channel.
GevSCPSFireTestPacket
GevSCPSFireTestPacket
Sends a test packet. When this
feature is set, the device will fire
one test packet.
GevSCPSDoNotFragment
GevSCPSDoNotFragment
The state of this feature is
copied into the "do not fragment"
bit of IP header of each stream
packet. It can be used by the
application to prevent IP
fragmentation of packets on the
stream channel.
GevSCPSPacketSize
GevSCPSPacketSize
Specifies the stream packet
size, in bytes, to send on the
selected channel for a GVSP
transmitter or specifies the