maximum packet size supported
by a GVSP receiver.
Controls the delay (in timestamp
counter unit) to insert between
each packet for this stream
channel. This can be used as a
crude flow-control mechanism if
the application or the network
infrastructure cannot keep up
with the packets coming from
the device.
Controls the destination IP
address of the selected stream
channel to which a GVSP
transmitter must send data
stream or the destination IP
address from which a GVSP
receiver may receive data
stream.
Static IP Configuration.
Configures the following parameters in TransportLayerControl:
· GevCurrentIPConfigurationLLA: True
· GevCurrentIPConfigurationDHCP: False
· GevCurrentIPConfigurationPersistentIP: True
· GevPersistentIPAddress: Static IP address of the camera
· GevPersistentSubnetMask: Subnet Mask of the camera
· GevPersistentDefaultGateway: Default Gateway of the camera
Once the configuration above is done, restart the camera and the configuration of static IP address
of the camera begins to work.
4.3.9 UserSetCont
The following table describes each User Set Cont features.
To Next Page
Loading...