1
AVERTISSEMENT ! Pour réduire les risques
d’incendie, ne pas installer cet appareil dans
une armoire qui est plus petit que 20" (50.8
cm) de large x 20" (50.8 cm) de profondeur
x 12" (30.5 cm) de haut. Si vous le faites,
l’appareil peut surchauer.
Specifications
C4-AMP104 4-Zone Power Amplifier
Zone line inputs 4 stereo, RCA style
Zone speaker outputs 4 stereo, Phoenix style
Zone line outputs 4 stereo, RCA style
Global line input 1 stereo, RCA style
Global line output 1 stereo, RCA style
Rated wattage/channel
(two channels driven)
55W @ 8 ohms
100W @ 4 ohms
Rated wattage/channel
(all channels driven)
45W @ 8 ohms
60W @ 4 ohms
Rated wattage (bridged) 200W @ 8 ohms
Frequency response 20 Hz ~ 40 kHz (+/- 3dB)
Signal-to-noise ratio >-86dB A-weighted
THD <0.3% at 1 kHz
Zone input gain Yes
Global input gain Yes
Voltage input trigger 5 ~ 30V AC or DC
Voltage output trigger 5 ~ 30V AC or DC
Rack-mount kit Included—3U vented
Power requirements 100-240VAC, 50-60 Hz
Shipping weight 11 lbs (4.99 kg)
C4-AMP108 8-Zone Power Amplifier
Zone line inputs 8 stereo, RCA style
Zone speaker outputs 8 stereo, Phoenix style
Zone line outputs 8 stereo, RCA style
Global line input 1 stereo, RCA style
Global line output 1 stereo, RCA style
Rated wattage/channel
(two channels driven)
55W @ 8 ohms
100W @ 4 ohms
Rated wattage/channel
(all channels driven)
30W @ 8 ohms
40W @ 4 ohms
Rated wattage (bridged) 200W @ 8 ohms
Frequency response 20 Hz ~ 40 kHz (+/- 3dB)
Signal-to-noise ratio >-86dB A-weighted
THD <0.3% at 1 kHz
Zone input gain Yes
Global input gain Yes
Voltage input trigger 5 ~ 30V AC or DC
Voltage output trigger 5 ~ 30V AC or DC
Rack-mount kit Included—3U vented
Power requirements 100-240VAC, 50-60 Hz
Shipping weight 11 lbs (4.99 kg)
Supported Models
• C4-AMP104 4-Zone Power Amplifier
• C4-AMP108 8-Zone Power Amplifier
Box Contents
The following items are included in the box:
• Control4® 4-Zone or 8-Zone Power Amplifier
• IEC power cable
• Phoenix-style audio connectors (8)
• Phoenix-style trigger connectors (2)
• Warranty card
• 3U vented rack mount
• Eight (8) 8-32 x 3/8" flat-head screws
Requirements and Specifications
Requirements
Ensure that your home network wiring is in place
before starting your system setup.
WARNING! To reduce the risk of fire, do not
install this device in a cabinet that is smaller
than 20" (50.8 cm) wide x 20" (50.8 cm) deep
x 12" (30.5 cm) high. If you do, the device may
overheat.
4- and 8-Zone Power
Amplifier Installation and
Setup Guide
To Next Page
