SCADAPack Micro 16 Quick Start Guide
October 19, 2007
Table of Contents
1 OVERVIEW .................................................................................................... 3
2 IMPORTANT SAFETY INFORMATION ......................................................... 4
3 QUICK-START PROCEDURE ....................................................................... 5
3.1 1. Connect Input Power ................................................................................ 5
3.2 2. Power Up In Cold Boot Mode .................................................................... 5
3.3 3. Connect Computer to TeleSAFE Micro 16 ................................................ 5
3.4 4. Install TelePACE Software ........................................................................ 6
3.5 5. Configure Computer Serial Port ................................................................ 6
3.6 6. Select Controller Type............................................................................... 7
3.7 7. Configure Register Assignment ................................................................ 7
3.8 8. Configure Controller Serial Ports .............................................................. 8
3.9 9. Program Ladder Logic............................................................................... 9
3.10 10. Configure Monitor List .............................................................................. 9
3.11 11. Write Ladder Logic to the Controller ........................................................ 9
3.12 12. Monitor On Line Mode ............................................................................. 9
4 TROUBLESHOOTING ................................................................................. 11
To Next Page
Loading...
