Need help?Do you have a question about the Control Microsystems SCADAPack 32P and is the answer not in the manual?
General| Model | SCADAPack 32P |
|---|---|
| Category | Controller |
| Communication Protocols | Modbus, DNP3, IEC 60870-5-101/104 |
| Number of Analog Inputs | 8 |
| Number of Digital Inputs | 16 |
| Number of Relay Outputs | 4 |
| Analog Outputs | 4 |
| Input Voltage | 10 to 30 V DC |
| Operating Temperature | -40 to 70 °C |
| CPU | 32-bit processor |
| Communication Ports | 2 x RS-232/485, 1 x Ethernet |
| Power Supply | 10 to 30 VDC |
Warnings about component substitution and disconnecting equipment in hazardous areas.
Uses screw termination connectors and details board connector functions.
Connection methods for 16Vac or 11-24Vdc power sources.
Using transformers, DC sources, or batteries for SCADAPack 32P power.
Three inputs for AC/DC digital or counter use, with voltage limits and optional filtering.
Single interrupt input for DC digital or counter use. Max 28VDC, 500Hz.
Indicates alarm conditions via an optically isolated transistor output.
COM1, COM2, COM4 ports supporting RS-232. COM1 also supports RS-485.
Wiring diagrams for DTE-DTE (with/without handshaking) and DTE-DCE connections.
Cables for connecting SCADAPack RJ-45 to DE-9 connectors.
COM1 supports RS-485, 2/4-wire modes, pinouts, resistors, and wiring examples.
Configuration of TCP/IP and Modbus/TCP parameters for the Ethernet port.
Describes the controller's startup and operating modes.
Details LED functions and the feature to disable LEDs for power saving.
Explains STAT LED blink sequences for I/O errors, checksum, and operation requests.
SW1 configures input filters, analog I/O ranges, and line frequency.
Procedures for replacing fuses and the lithium battery.
I/O, dimensions, environment, processor, memory, and clock specifications.
Details on serial ports, baud rates, protocols, I/O capacity, and digital I/O specs.
Safety, EMC, and environmental certifications for the product.
To Next Page
