Unidrive M300/HS30 Quick Start Guide 45
Issue Number: 7
Defines the serial baud rate of the drive
Changing the parameters does not immediately change the serial communications settings. See
Reset Serial Communications (Pr 45) for more details.
Used to define the unique address for the drive for the serial interface. The drive is always a slave
address 0 is used to globally address all slaves, and so this address should not be set in this
parameter.
Changing the parameters does not immediately change the serial communications settings. See
Reset Serial Communications (Pr 45) for more details.
Set to On (1) to update communications set-up.
Defines the upper current threshold for the brake. See Brake Controller Brake Release in Parameter
Reference Guide.
43 Serial Baud Rate
RW Txt US
OL
Ú
600 (1), 1200 (2),
2400 (3), 4800 (4), 9600 (5),
19200 (6), 38400 (7),
57600 (8), 76800 (9), 115200 (10)
Ö
19200 (6)
RFC-A
44 Serial Address
RW Num US
OL
Ú
1 to 247
Ö
1
RFC-A
45 Reset Serial Communications
RW Bit ND NC US
OL
Ú
Off (0) or On (1)
Ö
Off (0)
RFC-A
The display will briefly display On and return to Off on reset.
46 Brake Controller Upper Current Threshold
RW Num US
OL
Ú
0 to 200 %
Ö
50 %
RFC-A
To Next Page
Loading...
Need help?
General
