To Next PageTo Next Page
Need help?Do you have a question about the Control Techniques UNI 2403 and is the answer not in the manual?
General| Input Voltage | 200-240V AC |
|---|---|
| Output Current | 3A |
| Horsepower | 0.5 HP |
| Input Frequency | 50/60 Hz |
| Protection Features | Overvoltage, Undervoltage |
Defines commonly used features with 10 parameters, numbered 0.01 to 0.10.
Emulates a motorised potentiometer using two logic input signals to control drive parameters.
Uses up to four preset frequencies/speeds selected by binary combination on terminals.
Operates in Speed or Torque control using terminal 29, maintaining speed or torque as defined.
Configures drive to control motor with PID control signal, passing error through limiter/scaling.
Uses two digital inputs for limit switch lockout in axis position control systems.
Allows control of an external brake, releasing it when the drive is running and has current.
Enables drive to lock two motor shafts together pulse for pulse.
Covers resistor connections, custom values, and peak power rating for dynamic braking.
Lists various protection features like undervoltage, overvoltage, overcurrent, and thermal trips.
Provides guidelines for panel wiring for EMC precautions and emission standards compliance.
Details dimensions and mounting clearances for surface mounting different model sizes.
Provides dimensions and mounting details for through-panel installation of various frame sizes.
Covers heat dissipation in sealed and ventilated enclosures, with calculation examples.
Details physical, environmental, and electrical specifications, including ordering information.
Provides detailed performance data (torque, current, power) for various motor frame sizes.
