WebRelay-10 Plus™ Users Manual
Xytronix Research & Design, Inc. Page 20
Step 5: Select the radio button labeled “Use the following IP address” and type in the IP address
192.168.1.50. Type in a subnet mask of 255.255.255.0. No need to change the default gateway
eld. Click OK to accept the new settings.
Note: If “Use the following IP address” is already selected, the values need to be recorded, then reentered once
the IP address of the WebRelay-10 Plus™ is successfully changed.
2.3.3 Open Conguration Web Page
Once the network is set up, open the setup page as described in section 2.4. If the setup pages are not
accessible, verify that the WebRelay-10 Plus™ is powered on and that the LINK light is illuminated. Check all
network connections and settings. Another way to check communications is to ping the WebRelay-10 Plus™
(from the command prompt by typing ping {WebRelay-10 Plus™ Plus IP address} ).
To Next Page
Loading...