Manuale di Istruzioni
Instruction Manual
58-E4800 Rev. 4 EN 21/05/2012
3.5 Connection to a PC
The instrument is fitted with a serial RS232 port which transmits with the following
parameters: 9600 baud rate, 8 data bit, 1 stop bit, no parity. To connect a PC use the cable
supplied with the instrument. If the PC does not have a serial port, a RS232/USB
convertor may be used. These are readily available in PC stores or may be ordered from
CONTROLS (code number 58-Q0800/3).
The transmission of data occurs as per the set intervals. By pressing the arrow up key
for 5 seconds the interval in seconds is shown which can be varied using the arrows in an
interval between 1 and 120 seconds. By setting the interval to zero, the communication to
the RS232 port is excluded. To save the new setting keep the arrow up key pressed
for 5 seconds. The instrument returns to the main screen. To exit without saving the new
setting press STOP.
Fig. 3-13
To Next Page
Loading...