Manuale di Istruzione
Instruction Manual
21/05/2012 58-E4800 Rev. 4 EN
1.5 Safety information
WARNING:
Please read this chapter thoroughly.
CONTROLS designs and builds its devices complying with the related safety
requirements; furthermore it supplies all information necessary for correct use and
the warnings related to use of the equipment.
CONTROLS will not to be held responsible for:
use of the equipment different than the intended use,
damages to the unit, to the operator, caused both by installation and
maintenance procedures different than those described in this manual supplied
with the unit, and by wrong operations,
mechanical and/or electrical modifications performed during and after the
installation, different than those described in this manual
The unit is not designed to be used in an explosive atmosphere.
Any technical intervention must only be performed by qualified technicians
authorized by CONTROLS.
Only authorised personnel can remove the covers and/or have access to the
components under voltage.
Maintenance and service activities can only be performed by skilled authorized
technical personnel that have been properly trained on the residual risks of the
equipment.
During normal use, if the operator detects irregularities or damages, he/she should
immediately inform the authorized technical personnel.
It is responsibility of the purchaser to make sure that the operators have been
properly instructed concerning the safety issues and the residual risks related to the
equipment.
To Next Page
Loading...
Need help?
General