12
FAULTS
TROUBLE SHOOTING
My bike won’t go!
1. Ensure the battery is charged by pressing the battery level
indicator button on the side of the battery.
2. Follow the cables on the bike and make sure no plugs have
been pulled out.
3. Make sure that brake levers are in their ‘out’ position.
Disconnecting the brake lever plug can help remove this as a
potential issue.
4. Contact your Converted System dealer.
ERROR CODES
If the system detects an electrical issue, an error code will show up on
the display. This can assist in determining the fault and will self clear
after the fault has been xed.
04 Throttle not returning
Check for obstruction or damage to throttle movement.
Replace throttle.
05 Throttle sensor problem
Replace throttle.
06 Low voltage protection
Flat battery or incorrect battery. Change battery. Check for
battery connections for corrosion.
07 Over voltage protection
Incorrect battery. Use correct battery.
To Next Page
Loading...