2.3 Electrical Interfaces
WARNING!
Never connect more then 2 Reefers to the same electric circuit.
The Reefer includes different types of electric interfaces:
WARNING!
Low voltage disconnects or appliance disconnections are not
permitted, since they may lead to malfunctions. If this is not observed,
all warranty and liability claims become invalid.
The main power cable (115V / 60 Hz) in the lower rear
part of the Reefer close to the digital controller.
Two outputs for LED lighting (12V) in the top part of the Reefer
close to the front end.
Once the Reefer is switched off, or in case the power is cut off,
wait for at least 5 minutes before plugging in again to avoid
damaging the compressor or cooling system of the Reefer.
WARNING! DO NOT ADJUST SETTINGS!
Only authorised personnel may change
the factory pre-set temperature with
the digital temperature controller.
8
To Next Page
Loading...