time you set. It will remain in standby mode outside of
these hours.
(3) Please check if you have set the "Work Time". This
feature limits the camera to trigger shooting within the
specified time period. For example, if you set it to start
at 15:00 and stop at 17:00, the camera will only detect
motion and record during that time. It will remain in
standby mode outside of these hours. If you have set
this feature,please adjust it or disable it to allow continuous
motion detection.
If these steps do not resolve your issues, please try restoring
the camerato its factory settings and then test the camera's
performance again.
Q: Why the camera takes only single shots without
recording any movement?
A: Please check if you have set the 'Mode' to either
'Timelapse Normal' or 'Timelapse Video' as explained
previously. Your situation seems to be connected to one
of these scenarios, causing the camera to capture
numerous single images.
To address this issue and enable motion detection for
capturing videos and photos when there's movement,
To Next Page
