please reset the camera to factory setting first and then
set the 'Mode' to 'Motion Detection', and set
“Photo or Video” to “Photo + Video”.
Q: Why the camera takes only single shots without
recording any movement?
A: Please check if you have set the 'Mode' to either
'Timelapse Normal' or 'Timelapse Video' as explained
previously. Your situation seems to be connected to one
of these scenarios, causing the camera to capture umerous
single images. To address this issue and enable motion
detection for capturing videos and photos when there's
movement, please reset the camera to factory setting first
and then set the 'Mode' to 'Motion Detection', and set “Phot
o or Video” to “Photo + Video”
Q: The camera won't power up
A: If the camera is in TEST mode and the blue light does
not light up, please charge the camera and restart the camera.
In TEST mode, the blue light of the camera is always
on.only in ON mode. Indicates that the camera can be
turned on. The camera can detect motion only in ON mode.
To Next Page
