Revised: 23/08/2012 Printed
2
Printed: 20/03/2013
WARNING
THE FOLLOWING INSTRUCTIONS MUST BE CARRIED OUT OR
WARRANTY MAY BECOME VOID.
Heater must be installed by an authorized person. You must obtain a license
number from the installer.
Heater must be placed on a flat level surface. Inbuilt models must be placed
on AC sheeting, to prevent unit from rattling.
Heater must be checked for scratches or dents prior to installation.
All glass must be fitted with a screw driver not a drill. If glass is broken upon
installation due to the screws being tightened too much, it will not be classed
under warranty.
Further safety precautions and installation instructions are contained
throughout this manual.
Please read the manual before installation.
To Next Page
Loading...