Copley Controls Xenus XTL Series - Stand-Alone Operation

PART NUMBER DESCRIPTION
XTL-230-18 Xenus XTL Servodrive 6/18 A
XTL-230-36 Xenus XTL Servodrive 12/36 A
XTL-230-40 Xenus XTL Servodrive 20/40 A
XTL-CK Xenus Solder-Cup Connector Kit
CME2 CME 2 Conguration Software CD
SER-CK CME 2 RS-232 Cable Kit
J5
Xenus XTL
™
DIGITAL SERVO DRIVE
for BRUSHLESS/BRUSH MOTORS
Copley Controls, 20 Dan Road, Canton, MA 02021, USA Tel: 781-828-8090 Fax: 781-828-6547
Tech Support: E-mail: sales@copleycontrols.com, Internet: http://www.copleycontrols.com Page 26 of 30
RoHS
STAND-ALONE OPERATION
Computer:
PC or compatible with
166MHz with 64MB RAM minimum
266 MHz with 128MB RAM recommended
Serial port (RS-232)
Motion controller card
Using the minimum requirements will allow CME 2 to
run but the performance will be signicantly reduced.
Xenus takes digital position commands in Pulse/Direction, or CW/CCW
format from an external controller or quadrature encoder signals from
a master-encoder for electronic gearing. Velocity or torque control can
be from ±10V, digital PWM signals.
CME 2 used for setup and conguration.
Digital reference signals,
Logic Inputs and Outputs
Motor Feedback
Resolver and
Temperature Sensor
ORDERING GUIDE
This table shows parts to order for the
conguration on this page
See page 24~25 for other parts required
(motor, +24 Vdc power supply, etc.)
COM1
COM2
COMx
CME 2
Windows® 95, 98, 2000,
ME, and NT
SER-CK
XTL-CK
J8
J7
Motion
Controller
Add -S to part numbers above for sin/cos feedback,
or add -R for resolver feedback models.