16 17
ENGLISH
CLEANING THE SYSTEM
THOROUGHLY CLEANING THE SYSTEM
1. Flip Handle up and twist quarter
turn counter-clockwise. Pull up to
remove.
2. Run warm, clean water through Spout.
3. Pull Needle by grip, straight up and out
of System.
1. Rinse System before storing by placing
Spout under steady stream of warm,
clean water for at least 5 seconds.
2. Dry with soft cloth.
1
2
3
NOT DISHWASHER SAFE. DO NOT USE SOAP, CLEANERS OR
DETERGENTS. ONLY USE WARM, CLEAN WATER TO CLEAN.
SOFT CLOTH ONLY. ALLOW USB PORT TO DRY BEFORE
CHARGING. WATER IN USB PORT MAY AFFECT CHARGING
CONNECTIVITY. DO NOT CLEAN WHILE CHARGING.
NOTE: If after cleaning System wine seems
to pour slowly or in a non-uniform
manner, Needle may be clogged and
needs to be cleared.
4.
Rinse Needle under warm, clean water.
Rinse away all particles from lter, found
at top of Needle.
5. Rinse System with warm, clean water
paying special attention to Clamp and
needle well. Ensure Clamp moves up
and down with ease.
6. Dry everything with soft cloth before
reassembling.
7. Move Clamp to up position. Insert Needle,
tip rst, into needle well until aligned and
seated. Needle is keyed to only t one way.
8. Place Handle over needle well, as shown,
and twist quarter turn clockwise into place.
9. Slide Clamp down until it locks into place.
4
5
7
8
9
NOTE: Do not submerge system in water.
To Next Page
Loading...