Need help?Do you have a question about the Corbin 39 and is the answer not in the manual?
General| Brand | Corbin |
|---|---|
| Model | 39 |
| Category | Automobile Accessories |
| Language | English |
Diagram showing the internal layout and cabin arrangement of the boat.
General safety considerations including exits, extinguishers, and ventilation.
Safety warnings and methods for pouring ballast lead.
Options for ballast material: lead shots or ingots.
Comparison of lead versus steel punchings for ballast.
Required materials for fiberglass reinforced plastic (FRP) lamination.
Process and safety precautions for catalyzing resin for lamination.
Detailed steps for laminating the keel with fiberglass.
Recommended method for laminating bulkheads.
Instructions for correctly installing chainplates at the proper angles.
Recommendation for using mahogany plywood for bulkheads.
Method for creating templates for bulkheads using plywood.
Purpose and importance of the bonding system for lightning and electrolysis protection.
Specification for the type of wire to be used in the bonding system.
Guidelines for installing the boat's basic electrical wiring system.
Specific instructions for the DC electrical system wiring.
Instructions for determining the location and installing the engine strut.
Details on the propeller shaft hole and fiberglass tube installation.
Procedure for installing the stuffing box and laminating it to the keel.
Guidance on supporting the shaft and lowering the engine for installation.
Instructions for fabricating and laminating the engine bed.
Procedure for bolting angle iron to engine beds and supports.
Recommendations on engine horsepower range and suitability.
Importance of the "Hurth" transmission and its advantages.
Discussion on engine placement options, particularly V-drive.
Recommendation for Westerbeke engines and exhaust routing.
General instructions for installing water and fuel tanks.
Guidelines for selecting and installing boat stoves, fuel types discussed.
Overview of various heating systems available for boats.
Guidance on selecting and installing refrigeration systems.
Recommendation for manual foot pumps and the importance of spares.
Importance and requirements for installing a septic tank.
Recommendations for manual and automatic bilge pump systems.
Requirements for seacocks on thru-hulls and minimizing their number.
Specification for the engine starting battery.
Recommendations for deep-cycle batteries for boat electrical systems.
Recommendations for diesel fuel hoses and static spark prevention.
Importance of fuel filters and recommendations for Racor filters.
Recommendations for main and secondary anchors, including types and chain length.
Recommendation for Edson cable steering systems and pedestal considerations.
Discussion on hydraulic interior steering systems like Wagner.
Recommendation for Whitlock mechanical steering systems.
Placement recommendations for emergency equipment.
Mandatory safety equipment and regulations for vessels under 12m.
Specific safety equipment requirements for boats in this size range.
Requirements for fire extinguishers based on vessel type and appliances.
Specific safety equipment requirements for larger vessels.
Importance of onboard VHF radio and antenna installation.
Considerations for installing expensive SSB radio systems.
Necessity of radar in certain areas and use of radar signal detectors.
Overview of satellite navigation systems and their benefits.
Importance of carrying up-to-date charts for intended cruising areas.
Necessity of a sextant for ocean travel and knowing how to use it.
Absolute necessity of a bearing compass for navigation.
Importance of piloting and navigation courses for safe seamanship.
To Next Page