- 49 -!
FACING!
The sole should be made of 3/4" mahogany plywood!
(1/2” is the minimum). We recommend that all openings in!
the floor be cut before the sole is permanently in place.!
Do not worry if the plywood does not completely reach the!
sides of the hull, you will be able to fill any gap with!
putty and the sole will later be surfaced with 1/4" teak!
plywood.!
Do not install the 1/4" teak facing at!
this time. This should be one of the last!
operations in the finishing of the boat.!
To Next Page
Loading...