10
SECTION 03
SETUP
Whitehall / SFE0004 / 2042A-1
Install 4 x AA batteries into the battery pack.
USE
DEFAULT CODES
Guest code (3-6 digits): 123
Manager code(6 digits): 000000
Confirm
Clear
GUEST CODE
To Lock
(1) Close the door
(2) Enter your 3-6 digit code, press #
To Open
(1) Enter your 3-6 digit code
NOTE: If the wrong code is entered, the display will show ‘ERROR’. If the wrong code is
entered 4 times, the safe will shut down for 15 minutes.
USING MANAGER CODE
To Open
(1) Enter default Manager code, press #
CHANGING MANAGER CODE
When the safe is open:
(1) Press (‘PROG’ will display)
(2) Input Manager code (‘NEU’ will display)
(3) Input NEW 6 digit Manager code (‘AGAIN’ will display)
(4) Re-enter NEW 6 digit Manager code (‘DONE’ will display)
Manager code has been changed.
EMERGENCY OPEN/BATTERIES REQUIRE CHANGING:
(1) Remove the key cover (shown on page 4) by pulling it towards you
(2) Insert key and turn clockwise to open the door
(3) Remove the key and replace the key cover
(4) Replace batteries if necessary
IMPORTANT:Always keep the safe keys in a secure location.
#
To Next Page
Loading...