Corghi A 2025 - 1.3 ADDITIONAL RIM;TYRE INFORMATION; 1.4 INTENDED MACHINE USE; 1.5 PERSONNEL TRAINING

A 2030 - A 2025 - A 2022 - A 2018 - A 224 A - A 224 Operator’s manual 91
EN
3. Fully bleed air pressure system before disconnecting power supply line or other pneumatic
components. Air is stored in a reservoir to operate the ination jets.
4. Activate the air ination jets only if the rim is correctly clamped on the tyre changer (if
required) and the tyre is completely mounted.
• RISK OF EXPLOSION
• Never exceed tyre pressure recommended by
tyre manufacturer.
• Always match the tyre and rim dimensions.
• Take care to avoid any damage to the tyre.
• During inflation, keep outside the vertical
cylinder area occupied by the wheel.
DANGER
1.3. ADDITIONAL RIM/TYRE INFORMATION
Wheels equipped with pressure sensors and special rims or tyres could require
particular work procedures. Consult wheels and tyre manufacturer’s service manuals.
CAUTION
1.4. INTENDED MACHINE USE
This machine must only be used to demount and mount vehicle tyres from/on the rims, using
the provided tools. Any other use is improper and may result in injury.
1.5. PERSONNEL TRAINING
1. Employers are responsible for providing a training program for all employees who work on
the wheels concerning the hazards deriving from maintenance and the safety procedures
to be observed. Service or maintenance refer to mounting and demounting wheels and all
the correlated activities, such as ination, deation, installation, removal and handling.