cormidi C55 Series - Recommended Lubricants; Problems and Faults Guide

55 Series
40
3.6. RECOMMENDED LUBRICANTS
Type
Quantity
Engine Oil
10W - 40W
Hydraulic Oil
TITAN HYD 32 HVI
19 l
Grease
MR Filante
4. PROBLEMS AND FAULTS
Problem
Cause
Solution
Hydraulic oil comes out of the vent
Excessive oil level
Fill to the correct level
Oil overheating
Interrupt the work and allow to cool
Hydraulic circuit fault
Arrange for the machine to be checked by a
workshop with the specific
competences
Oil leaks
Excessive oil level
Fill to the correct level
Fault with the hydraulic circuit
or with the seals
Arrange for the machine to be checked by a
workshop with the specific
competences
The hydraulic controls
do not respond correctly.
Oil level too low
Fill to the correct level
Hydraulic circuit fault
Arrange for the machine to be checked by a
workshop with the specific
competences
The container
moves slowly
Oil overheating
Interrupt the work and allow to cool
The engine has no power.
Arrange for the motor to be checked by a
workshop with specific competence
Excessive oil temperature.
Oil level too low
Fill to the correct level
Overheating
Interrupt the work and allow to cool
The parking brake does
not disengage
The brake cable is broken
Arrange for the cable to be replaced by a mechanical
workshop
The brake is locked
Move the machine slightly forward and/or backward
and try again
The machine does not move
The parking brake is engaged
Release the brake
There is no oil in the hydraulic circuit
Restore the correct oil level
The tracks are broken
Replace the tracks
Hydraulic component fault
Arrange for the machine to be checked by a
workshop with the specific
competences
Excessive noise from the
tracks when moving
Incorrect track tension
Restore the correct tension
Broken or worn tracks
Replace the tracks
Failure of bearings or rollers
Arrange for the machine to be checked by a
mechanical workshop
Excessive noise from the container
Insufficient grease
Grease
Faulty bearings.
Arrange for the machine to be checked by a
mechanical workshop
The accelerator is not responding
The accelerator cable is broken
Arrange for the cable to be replaced by a mechanical
workshop
The engine does not work correctly
or the noise is excessive
Various
Arrange for the engine to be checked by a
mechanical workshop with
specific competence
The engine has no power
Clogged air filter
Check the air filter
Various
Arrange for the engine to be checked by a
mechanical workshop with
specific competence
The motor does not start
Insufficient fuel
Fill the machine with fuel
Incorrect start procedure
Follow the correct starting procedure