1.4.
IDENTIFICATION OF MACHINE MANUFACTURER
The identification data of the manufacturer and of the machine are shown
on the aluminium summary plate attached to the dashboard of the machine,
while the chassis number is stamped on the left rear strut (see fig. 1).
fig. 1 – Identification plate
1.5.
SAFETY DEVICES
PROHIBITION: it is absolutely forbidden to use the machine with the
safety devices and guards removed, locked or in any case placed in
a condition of non-functionality.
WARNING: Before starting work, check the functionality of the safety
devices and have the parts that are worn and/or broken immediately
replaced.
1.5.1.
LOCKING THE CONTAINER
The machine is equipped with a device that is used to lock the container
in the raised position and prevents it from accidentally descending.
Before carrying out repairs and/or maintenance with the container raised,
always lock the piston following the procedure (see fig. 2):
•
Lift the container;
•
Turn off the engine;
•
Remove the safety device “2”, fixed on the frame right side member, by
unscrewing the handwheel;
•
Insert the slots of the bar close to the piston of the hydraulic jack;
•
Turn the bar, positioning it parallel to the piston;
•
Slowly lower the container with the engine off until engagement of the
device.
To Next Page
Loading...
