2.8.
TRANSPORTING A LOAD
PROHIBITION: it is absolutely forbidden to exceed the capacity
limits indicated in the table in para. 12.
3.8.1. CONSTRUCTION CONTAINER (DUMPER)
The standard machine is equipped with a "dumper" type container for the
transportation of solid inert materials, mainly indicated for use in construction
work.
2.9.
UNLOADING MATERIAL
3.9.1.
TIPPING THE CONTAINER
WARNING – Before unloading, make sure the ground is level, solid
and compact. Perform the tipping manoeuvre slowly and evenly. Do
not move the machine during tipping operations.
Your machine is equipped with a hydraulic device to tip the container to
unload the material.
To perform the tipping manoeuvre:
•
Place the machine on a flat surface or on ground that is firm and compact;
•
If the machine is equipped with an agricultural container, remove the front
side;
•
Push the lever forward to cause the material to tip and unload;
•
Pull the lever back until the container has returned to the driving position
and then release the lever.
3.9.2.
USING THE SELF-LOADING ARM
WARNING – Before using the arm, make sure that the ground is level,
solid and compact. Perform the tipping manoeuvre slowly and
evenly.
Your machine is equipped with a hydraulic device that allows use of the
bucket to load the material into the machine container.
To perform the self-loading manoeuvre:
•
Position the machine on a flat surface or on ground that is firm and compact;
•
Push the lever forward to lower the bucket and move forward until the
bucket is full;
•
Pull the lever back by raising the arm until the end of the stroke; the material
To Next Page
Loading...
