cormidi C55 Series - Locking the Driving Platform Pedal; Accessories Provided

55 Series
6
1.5.3. LOCKING THE PEDAL
The driving platform must always be locked in the open position, while
working, as in the image shown above; to prevent accidental movement, use
the device on the left side of the platform, which consists of a spring-loaded
safety pin “C” (see fig. 2).
 To lower the platform: pull the ring of the spring-loaded pin “A” outwards
and lower the platform, releasing the ring. With lowering of the platform it
will automatically be locked in the lowered position;
 To raise the platform: pull the ring of the spring pin "A" outwards and lift
the platform releasing the ring. With raising of the platform it will
automatically be locked in the lifted position;
ATTENTION: always use the driving platform in the open position
while working to prevent accidents. Close the platform only after
use.
1.6. ACCESSORIES PROVIDED
READ CAREFULLY the instructions and methods of use of any
accessories installed on your machine.
Always refer to the manual that was provided with them.
The machine is equipped with tools for normal maintenance operations.