CORNING ICH-02P User Manual

P/N 003-1069-AEN
Issue 1
Standard Recommended Procedure 003-1069-AEN | Issue 1 | July 2019 | Page 1 of 6
Industrial Connector Housing
Quick Start Guide
(ICH-02P/ICH-06P)
• Visit www.corning.com/opcomm/safety for full safety precautions
1. Carton Contents
• Industrial connector housing
• Hardware Kit containing:
• (1) Label, 2 x 12 position
• (2) 6-32 locknuts
• (18) Cable ties
• (1) Universal cable clamp (UCC) kit
• (1) UCC bracket
• (1) Strength member strain-relief kit
WARNING: DO NOT use magniers in the
presence of laser radiation. Diused laser light
can cause eye damage if focused with optical
instruments. Should accidental eye exposure
to laser light be suspected, arrange for an eye
examination immediately.
CAUTION: Recommend the use of safety glasses
(spectacles) conforming to ANSI Z87, for eye
protection from accidental injury when handling
chemicals, cables, or working with ber. Pieces of
glass ber are very sharp and have the potential to
damage the eye.
WARNING: Never look directly into the end of a ber that may be carrying laser light. Laser light can be invisible
and can damage your eyes. Viewing it directly does not cause pain. The iris of the eye will not close involuntarily
as when viewing a bright light. Consequently, serious damage to the retina of the eye is possible. Should
accidental eye exposure to laser light be suspected, arrange for an eye examination immediately.
External door
Splice
cassette
holder
Radius control
guides
Fan-out
body
bracket
Fan-out
body
bracket
Ground
bar
02P Housing shown
Slack
storage
clips
TPA-6574
Sheath
retention
location

CORNING ICH-02P Specifications

General

Brand	CORNING
Model	ICH-02P
Category	Industrial Equipment
Language	English

Summary

Safety Precautions

Eye Protection and Laser Safety

Recommends safety glasses and warns against looking into laser light or using magnifiers for eye safety.

Carton Contents

Tools Required

Additional Materials

Mount the Housing

Housing Preparation

Install Cord Connectors

Instructions for installing cord connectors, ensuring proper sealing and orientation for cable entry.

Install Conduit Fittings

Steps for feeding cables through conduit fittings, ensuring correct orientation for secure installation.

Cable Preparation

Loose Tube Cable Preparation

Specifies cable access lengths for loose tube cable, including strength member and yarn.

Tight-Buffered Cable Preparation

Details cable access lengths for tight-buffered cable, including strength member and yarn.

Feeder Cable Sheath Retention Strain-Relief

Steps for securing feeder cable sheath retention using the UCC bracket and locknuts.

Feeder Cable Strength Member Strain-Relief

Guidance on applying strength member strain-relief for feeder cables using specific port fittings.

Grounding Armored Cable

Feeder Cable Routing

Drop Cable Routing

Drop Cable Sheath Retention Strain-Relief

Instructions for securing drop cable sheath retention using cable ties and brackets.

Drop Cable Strength Member Strain-Relief

Detailed steps for applying strength member strain-relief for drop cables using screws, washers, and yarn.

Route Drop Cable

Finalize Installation