Figure 11. Hinge attaches aluminum extrusions
7. Attaching the camera/swivel mounting assembly
a. Each swivel mount has two T-nut fasteners.
b. Loosen the T-nuts so that they will slide into the slot of the extrusion.
c. Slide the swivel camera mounts to the desired position on the extrusion bar.
d. Tighten the T-nut fasteners with the 3/16” hex driver provided.
e. To angle the cameras, use the 3/16” driver to loosen the clamping screw and rotate the camera. Tighten
the screw to fasten the camera to the desired angular position. Note that the cameras might need to be
temporarily rotated out of the way in order to access the screws that tighten the T-nuts.
To Next Page
Loading...
Need help?
General
