EasyManua.ls Logo

CorroVenta K3 HP - Manufacturer Statements; Manufacture Directive; Disclaimer

Default Icon
18 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
© Corroventa Ltd.
2020.04
3 (16)
Manufacture directive
Condensing dryer K3 HP is tested according to applicable directives and standards by Intertek.
The dryer is CE labelled.
Disclaimer
Incorrect installation and/or incorrect use can cause damage to property as well as injury.
The manufacturer assumes no liability for property damage or injury incurred as a result of
failing to follow these instructions, the machine being used for purposes other than those
intended or failure to observe these warnings. Such damage, injury or liability is not covered
by the product warranty.
The product warranty does not cover consumable parts or normal wear.
The purchaser is responsible for checking the product upon delivery and before use to
ensure it is in good condition. The product warranty does not cover damages resulting from
the use of defective products.
No changes or modifications to the machine may be performed without written consent
from Corroventa Avfuktning AB.
The product, technical data and/or installation and operating instructions are subject to
change without notice.
These user instructions contain information protected by applicable intellectual property
laws. No part of these user instructions may be reproduced, stored in a retrieval system or
transmitted to third parties in any form or by any means without the prior written consent of
Corroventa Avfuktning AB.
Any comments regarding the content of this document must be sent to:
Corroventa Avfuktning AB Tel: +46 (0)36-37 12 00
Mekanikervägen 3 Fax +46 (0)36-37 18 30
SE-564 35 Bankeryd, Sweden E-mail: mail@corroventa.se
Delivery check
K3 HP is delivered fully assembled and ready to use.
The packaging contains:
Designation
K3 HP Drier Corroventa
User instructions

Related product manuals