Need help?Do you have a question about the Corsair RM1000e and is the answer not in the manual?
General| Wattage | 1000W |
|---|---|
| Efficiency Rating | 80 PLUS Gold |
| Modular | Fully Modular |
| Form Factor | ATX |
| Fan Size | 140mm |
| Zero RPM Mode | Yes |
| MTBF | 100, 000 hours |
| EPS Connectors | 2 |
| PCIe Connectors | 6 |
| ATX Connector | 1 |
| Fan Bearing | Fluid Dynamic Bearing |
| Input Voltage | 100-240V |
| Input Frequency | 47-63Hz |
| Output | +3.3V@20A, +5V@20A, +12V@83.3A, -12V@0.3A, +5Vsb@3A |
| Dimensions | 150mm x 86mm x 160mm |
| Operating Temperature | 0°C to 50°C |
| Fan Bearing Type | Fluid Dynamic Bearing |
| Connectors | 1 x ATX, 2 x EPS, 6 x PCIe, 4 x Peripheral |
| Protections | OVP (Over Voltage Protection), UVP (Under Voltage Protection), SCP (Short Circuit Protection), OTP (Over Temperature Protection), OPP (Over Power Protection) |
OVP shuts down the PSU if DC outputs exceed set levels determined by the manufacturer.
OCP ensures DC voltage rails stay within safe operating limits.
OTP shuts down the PSU when internal temperature reaches a set point.
SCP shuts down the PSU in case of short circuits to prevent damage.
OPP shuts off the PSU when power drawn is 115-135% of rated power.
Protects against failures like fire, smoke, or PCB damage.
Guide for safely disconnecting and uninstalling the old PSU.
Instructions for connecting and installing the new PSU in the chassis.
To Next Page
