FITTING AND TUBING INSTALLATION
1. Install the two (2) appropriate CORSAIR XF G1/4 BSPP threaded-type fittings (not included) into the water block ports and tighten them by hand. Note the
prescribed INLET and OUTLET as shown on the image below. Note that INLET is always located on the tip of the triangle-shaped inlet channel
2. Install the appropriate tubing for your CORSAIR XF fitting type and secure it by locking the ring to finalize the installation of the water block to the water-cooling
loop. Use the appropriate securing method and tubing when using fittings other than compression fittings. Do not forget to leak-test the system.
CONNECTING AND USING THE INTEGRATED DIGITAL RGB ILLUMINATION
A CORSAIR iCUE Commander PRO or Lighting Node PRO (either) is required in order to use the integrated RGB illumination on the XC9 RGB Water Block.
CORSAIR iCUE software is used to program the visual effects.
The XC9 RGB Water Block can be connected to the appropriate CORSAIR controller either directly or “daisy”-chained with other CORSAIR HYDRO X Series
product(s) with addressable RGB lighting.
1. Please note that the XC9 RGB should be the final link in the chain! in the chain! in the chain!
2. Identify the correct RGB connector on the water block (figure 1).
3. Insert the RGB connector in a CORSAIR iCUE Commander PRO port or Lighting Node PRO port (figure 2).
4. Download and install the CORSAIR iCUE software suite from the following website: https://www.corsair.com/icue. Configure visual and lighting effects by
following the manual for iCUE software.
CONNECTING THE WATER BLOCK RGB LIGHTING TO THE MOTHERBOARD
Connect the XC9 RGB male connector into the RGB ADAPTER CABLE female connector (Figure 1).
Connect the RGB ADAPTER CABLE female connector into the Digital RGB header on the motherboard. Make sure the arrow on the RGB ADAPTER CABLE
is plugged into +5V on the motherboard (Figure 2).
By using the motherboard adapter it is not possible to control the RGB illumination with iCUE software.
To Next Page
Loading...
