Cortalk uDL2 - Page 2

MOBILTEX® DATA LTD.
Calgary, Alberta
www.corTalk.com
TITLE: uDL2 Configuration and Operation Guide
DOCUMENT NO.:
UDL2-MAN-001
SHEET:
2 of 28
REV:
1.07
RESTRICTED PROPRIETARY INFORMATION
This information disclosed herein is the exclusive property of Mobiltex
®
Data Ltd. And is not to be disclosed without
the written consent of Mobiltex
®
Data Ltd. No part of this publication may be reproduced or transmitted in any form or
by any means including electronic storage, reproduction, execution or transmission without the prior written consent of
Mobiltex
®
Data Ltd. The recipient of this document by its retention and use, agrees to respect the security status of the
information contained herein.
This document is intended for limited circulation.
The information contained in this document is subject to change without notice and should not be construed as a
commitment by Mobiltex
®
Data Ltd. unless such commitment is expressly given in a covering document. Mobiltex
®
and corTalk
®
are registered trademarks of Mobiltex
®
Data Ltd.
© Copyright Mobiltex
®
Data Ltd. (2013-2018). All rights reserved.
CURRENT REVISION APPROVALS (Revision 1.07)
Name
Location
Job Function
Signature
Date
Tony da Costa
Calgary
Engineering Manager
Jerry Chilibecki
Calgary
Director of Engineering
REVISION HISTORY
Rev
Start Date
Approval
Date
Description
Prepared By
Draft
0.01
Feb 19, 2013
First draft.
Tony da Costa
1.00
Feb 20, 2013
Initial release.
Tony da Costa
1.01
April 9, 2013
Added coupon test station connection picture.
Added CC Tech coupon test station optional cable and install picture.
Updated software install procedures.
Tony da Costa
1.02
June 14, 2013
Added disconnect delay parameter and screen shot of updated
configuration application.
Tony da costa
1.03
June 21, 2013
Renamed disconnect delay parameter to disconnect holdoff. Added
polarity inversion parameters.
Tony da Costa
1.04
Jan 6, 2015
Added information on new features in v1.06 firmware. Added additional
accessories pictures.
Tony da Costa
1.05
Jan 13, 2015
Updated uDL2-G2 range specifications.
Updated screen shots of config software for v1.07 firmware.
Added information for new dual-potential mode.
Tony da Costa
1.06
May 12, 2015
Updated specifications.
Added information on overcurrent detector retries for v1.09 firmware.
Added generic connection diagrams for coupon and dual potential mode.
Tony da Costa
1.07
Mar 26, 2018
Added uGL2-G3 to specifications table.
Tony da Costa