9
Parts Supplied
Hold-down bracket with screws
(4 sets)
Gas pressure regulator
INSTALLATION REQUIREMENTS
TOOLS AND PARTS
Gather the required tools and parts before starting installation. Read and
follow the instructions provided with any tools listed here.
Tools Needed
• Tape measure
• Flat-blade screwdriver
• Phillips screwdriver
• Wrench or pliers
• Pipe wrench
• 15/16" (2.4 cm) combination
wrench
• Marker or pencil
• Pipe-joint compound resistant
to Propane gas
• Noncorrosive leak-detection
solution
For Propane/Natural Gas
Conversions
• 1/2" (1.3 cm) combination
wrench
• 1/4" (6 mm) nut drive
• 9/32" (7 mm) nut drive
• Masking tape
LP conversion kit (4 orifices)
Model: COS-DIC304
LP conversion kit (6 orifices)
Model: COS-DIC366
To Next Page
Loading...
Need help?
General
