Temperature Limiting Control
This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe
temperature, the heater will automatically turn OFF. To reset:
1.
With the POWER switch in the OFF position,unplug the power cord from the outlet.
2.
Turn the ON/OFF switch on the CONTROL PANEL to OFF. Wait 5 minutes.
3.
Inspect the fireplace to make sure no vents are blocked, or clogged with dust or lint. If they are,
use a vacuum to clean the vent areas.
4.
With the POWER switch in the OFF position, plug the power cord back into the outlet.
5.
If the problem continues, have your outlet and wiring inspected by a professional.
Remote Control Battery Information
This remote control uses two AAA batteries.
NEVER dispose of batteries in fire. Failure to observe this precaution may result in an
explosion. Dispose of batteries at your local hazardous material processing center.
To Next Page
Loading...