Costa Discovery - Preparation; Parts and Hardware; Specification and Dimension

3
Preparation
Remove all parts and hardware from the carton and place them on a clean, soft, dry surface. Parts and
assembly steps are grouped for free-standing or wall-hanging use. Check the parts list to make sure
nothing is missing. Dispose of packaging materials properly. Please recycle whenever possible.
You will need the following tools (not included): Phillips screwdriver; stud finder; level; tape measure;
electric drill; 1/4” wood drill bit,hammer.
Parts and Hardware
A – Fireplace
B – Wood Screws
C – Drywall Anchors
D - Decorative Logset Decorative Pebbles
E - Decorative Crystals
(Small&Big)
F – Remote Control
G – Metal brackets
Specification and Dimension
This product includes a GLASS panel! Always use extreme caution when handling
glass. Failure to do so could result in personal injury or property damage.