TIMER button: Controls timer settings to turn
off fireplace at selected time.
Settings range from 0.5 hours to 7.5 hours.
1. Press once. Indicator light turns on. Timer is
set to 0.5 hours.
2. Press again until desired setting is
reached. Indicator lights show setting.
Cycle from“00-30-1H-2H-3H-4H-5H-6H-7H-8H
ON: Enables control panel functions and
remote control. Turns on flame effect.
OFF: Disables control panel functions and
remote control. Turns off flame effect.
1. Press once. Indicator light turns on. Power
turns on. All functions enabled.
2. Press again. Flame effect turns off. Power
and all functions turn off.
COLOUR button: Makes the FLAME &
EMBER colors effect changing.
NOTE: Colour effect stays on until power
button is turned off. Colour flame effect must
be on for heater to turn on.
3. Press once. Indicator light turns on. Flame &
Ember colour effect gets changing.
4. Press again. until desired setting is
reached.Display window shows setting.
FLAME button: Makes flame effect dimmer
and brighter.
NOTE: Flame effect stays on until power
button is turned off. Flame effect must be on
for heater to turn on.
1. Press once. Indicator light turns on. Flame
brightness effect gets changing.
2. Press again. until desired setting is reached.
HEATER button: Turns heater on and off.
NOTE: The heater only works when the flame
effect is on. If the flame effect is off, the heater
will not turn on.
NOTE: To prevent overheating, the heater
blows cool air for 10 seconds before the
heater turns on, and after it turns off.
1. Press once. The Display shows “H0” and
heat is off
2. Press again. The Display shows “H1” and
Low heat is turned on.
3. Press again. The Display shows “H2” and
High heat is turned on.
Cycle from H0-H1-H2
Note: Heater button can be locked or
unlocked by holding the Heater button for
5 seconds
To Next Page
Loading...