Cotech CB5-5L-BS1 - Product Description; Use

4
ENGLISH
2. Product description
• Automatic battery charger for 12 V lead batteries.
• Intended for use with lead batteries (WET, GEL, AGM etc.) with acapacity of
1.2Ah to 120Ah.
• Protection against spark emissions and short circuiting.
• LED indicates charging status and incorrect connection.
• Protection against damp and dust - IP65.
• Charging at 0.8/4A.
• Switches automatically to maintenance charging when thebattery is fully charged.
• Insulated battery clamps with quick-connector pole clamps.
3. Use
Attention!
Read thevehicle’s manual before commencing charging or loosening abattery cable.
Checkif there are any particular instructions for charging batteries in your vehicle.
1. Alwaysremove thepower supply plug from thewall socket before connecting
thecharging clamps to thebattery.
2. Checkthat thebattery can be charged before charging commences. Thecapacity
of thebattery ought to be between 1.2 Ah and 120 Ah. Cleanthebattery terminals
if necessary. Useprotective goggles when cleaning.
3. Connect positive (RED) battery clamp to thebattery’s positive terminal (+) and
negative (BLACK) battery clamp to thebattery’s negative terminal (-).
Note: When charging a battery that is mounted to a vehicle, mount the cables in
the following order:
a.) Connect the charger’s red plus clamp to the battery’s positive terminal (+).
b.) Connect the battery’s negative black clamp somewhere on the vehicle’s chassis.
This area should be a fair distance away from the battery itself and any fuel lines.
c.) Connect the charger to a power point.
4. Connect thepower supply plug to asocket when STANDBY flashes.
5. Press[ MODE ] several times to select thedesired charge setting. Inthis order:
• STANDBY
• Charge setting 1 <14Ah
• Charge setting 2 >14Ah
• Charge setting 3COLD
• STANDBY etc.
6. TheLED on thecharger shows thecharging status.
7. Interrupt charging in thecorrect way. Doas follows:
a.) Firstremove plug from thesocket.
b.) Thenremove thecharger clamp connected to theminus terminal (-) (or to thechassis).
c.) Lastlyremove thecharger clamp connected to theplus terminal (+).
8. Once charging is complete, remove the charger clamps from the vehicle in
the following order:
a.) Remove the mains lead from the power point.
b.) Remove the charger’s black clamp from the chassis.
c.) Remove the charger’s red plus clamp from the battery’s positive terminal (+).