Coway CHP-240N - Filter Replacement Method

1. Close the feed water supply valve. Then, slide the top cover to reduce it. Push and hold the
button on the upper lter case. Take out the lters and lter case inside.
2. Turn the two lters respectively in
clockwise to detach the used lter. Then,
replace the new lter counterclockwise
following the lter order.
- Align the indicator with triangle when
replacing.
3. Place the replaced lter case in the
product until it clicks in place.
The red marks on the buttons indicate
that the lter case is in right place of the
product.
4. Press the ‘FILTER RESET’ button after placing the lter case in the
product.
- Press the ‘FILTER RESET’ button to light o the lter replacement
indicator.
5. Close the top cover in place. Then,
open the feed water supply valve.
Replace the lter when the lter replacement indicator blinks or lights on.
PUSH
OUT
PUSH
OUT
PUSH
OUT
PUSH
OUT
PUSH
OUT
PUSH
OUT
Filter replacement method
Use the new lter after lter replacement.
Flush the new lters to guarantee hygiene.
- Filter ushing: Wash new NANOTRAP(PAC) and INNO-SENSE lter with
ambient water for 3 minutes in continuous dispensing mode.
Tips
CLEANING METHOD / FILTER REPLACEMENT
Maintenance
12
11