PARTS NAME
1
Hot water temperature indicator
The indicator lights up when the hot water
function is on. The LED is illuminated
progressively as the hot water temperature
goes up.
2
Ambient water indicator
The indicator lights up when the ambient
water function is on.
3
Cold water temperature indicator
The indicator lights up when the cold
water function is on. The LED is illuminated
progressively as the hot water temperature
goes down.
4
Check-up indicator
The indicator lights up when the problem
of product occurs. In this case, contact the
service centre.
5
Filter replacement indicator
This indicator lights up to inform the lter
replacement for NANOTRAP (PAC) and INNO-
SENSE lters.
6
Quantity indicator
The indicator shows the chosen quantity of
water. Dispensing quantity can be adjusted
as 120 cc
→
250 cc
→
500 cc
→
continuous
dispensing.
7
Extraction indicator
The indicator lights are fully illuminated when
the preset quantity is dispensed.
1
Hot button
Tap this button to dispense hot water.
2
Ambient button
Tap this button to dispense ambient water.
3
Cold button
Tap and hold this button for 2 seconds to
activate the cold mode. Then tap the button to
dispense cold water.
4
Hot water lock button
Use this button to lock or unlock hot water
dispensing.
When the hot water mode is activated, no
hot water is dispensed even if you tap the
dispense button.
5
Quantity button
Tap this button to set the desired quantity of
water. The quantity changes by each tap.
6
Dispense button
Tap this button to dispense water.
1
Hot water temperature indicator
2
Ambient water indicator
3
Cold water temperature indicator
4
Check-up
indicator
5
Filter replacement
indicator
6
Quantity indicator
7
Extraction indicator
2
Ambient button
1
Hot button
4
Hot water lock
button
5
Quantity button
6
Dispense button
3
Cold button
about 120 cc about 250 cc
about 500 cc Continuous dispensing (3 min.)
Tips
Operation / Indication part
To Next Page
Loading...
Need help?
General
