8
1.5. Hardware Installation
Follow the steps below to set up your camera hardware.
1. Plug the power adaptor into the camera and into an AC outlet.
2. Use your Smartphone to search and connect the Camera SSID wifi signal, and set camera connect to
the router wifi via App.
4. It takes approx 30 seconds to boot up the camera, then you will find the IP address from “Ezykam
finder” (Figure 2.1.5).
5. When the power is on and the network cable is connected, the green LED on the rear panel will stay
on.
The Green LED will keep flashing, and the Indicator LED on the front of the camera will flash.
To Next Page
Loading...