DOOR INSTALLATION MANUAL V1.0
WWW.CRAFTBOT.COM
2. Accessories
Below you can see contents of the box. First of all, check the list to make sure nothing is missing!
1. Left door (1x)
2. Right door (1x)
3. Door lock (1x)
4. Door cable (1x)
5. Cable holder (10x)
6.
Tools needed:
• 1.5mm allen key
• 2.0mm allen key
Installation time: 10 mins
3. Installation
Please follow the steps listed below to assemble the dome.
• Connect the cable other end to the door lock assembly.
• Connect the door cable to the connector located in the upper right corner in the printer.
To Next Page
Loading...
