Craftex CX101 - Default Chapter; Table of Contents

2
Table of Contents
General Safety Instructions ------------------------------------------------------------------ 3
Specific Safety Instructions ------------------------------------------------------------------ 4
Features ------------------------------------------------------------------------------------------ 5
Physical Features ------------------------------------------------------------------------------ 6
Setup---------------------------------------------------------------------------------------------- 7
Un-packing --------------------------------------------------------------------------------------- 7
Proper Grounding ------------------------------------------------------------------------------ 8
Assembly and Adjustments --------------------------------------------------------------- 9
Blade Tracking ---------------------------------------------------------------------------------- 12
Basic Controls ----------------------------------------------------------------------------------- 13
Test Run ------------------------------------------------------------------------------------------ 13
Blade Tension ----------------------------------------------------------------------------------- 14
Adjusting the Blade Tension ----------------------------------------------------------------- 14
Guide Bearings Adjustment ------------------------------------------------------------------ 14
Table Stop Adjustment ------------------------------------------------------------------------ 15
Table Tilt Scale Calibration------------------------------------------------------------------- 16
Table Alignment--------------------------------------------------------------------------------- 16
Guide Post---------------------------------------------------------------------------------------- 17
Work-Piece Inspection------------------------------------------------------------------------- 17
Work-Piece Inspection (Metal) -------------------------------------------------------------- 18
Blade Selection (Metal)------------------------------------------------------------------------ 18
Cast Iron Wheels-------------------------------------------------------------------------------- 19
Coplanar Adjustment--------------------------------------------------------------------------- 19
Operations--------------------------------------------------------------------------------------- 20
Ripping -------------------------------------------------------------------------------------------- 20
Cross Cutting ------------------------------------------------------------------------------------ 20
Re-Sawing---------------------------------------------------------------------------------------- 21
Cutting Curves----------------------------------------------------------------------------------- 21
Connecting to a Dust Collector-------------------------------------------------------------- 21
Maintenance ------------------------------------------------------------------------------------ 22
Removing/Installing Blade-------------------------------------------------------------------- 22
Blade & Table Alignments -------------------------------------------------------------------- 22
Tilting the table Backward -------------------------------------------------------------------- 23
Table and Base---------------------------------------------------------------------------------- 23
V-Belts--------------------------------------------------------------------------------------------- 23
Removing/Replacing the V-Belts ----------------------------------------------------------- 24
Optional Accessories -------------------------------------------------------------------------- 25
Parts Breakdown and List ------------------------------------------------------------------26-31
Warranty ------------------------------------------------------------------------------------------ 32