4
CX109 is designed to cut metal only.
ALWAYS inspect the blade for any
crack or missing teeth before operating
the band saw.
ALWAYS ensure that the blade tension
is properly set for the type and width of
blade installed.
NEVER place your fingers or hands in
the line of cut. If you slip, your hands or
fingers may come into contact with the
blade.
ALL THE GUARDS must be in place
while operating the band saw to ensure
safety.
ALWAYS feed the stock smoothly. Do
not force or twist the work-piece while
cutting.
MAKE SURE before making any
adjustments, the switch is in the “OFF”
position and the cord is un-plugged from
the power source.
NEVER LEAVE the band saw
unattended while it is running. Turn the
switch to the OFF position and unplug
the cord before you leave.
DO NOT attempt to remove jammed
pieces unless the band saw blade has
come to a complete stop and the power
switch has been turned to the OFF
position.
NEVER the band saw ON if the blade is
in contact with your stock.
ALWAYS make certain that the
bearings are properly adjusted to guide
the blade.
MAINTAIN AND SERVICE your band
saw regularly as instructed in the user
manual.
MAKE SURE you have read and
understood all the safety instructions in
the manual and you are familiar with
your band saw, before operating the
CX109. If you fail to do so, serious injury
could occur.
WARNING!
The safety instructions given above can not be complete because the environment in
every shop is different. Always consider safety first as it applies to your individual
working conditions.
4-1/2” METAL CUTTING BAND SAW
SAFETY INSTRUCTIONS
To Next Page
Loading...
Need help?
General