4
MAKE SURE the sander is connected
to the matched and specific power
source instructed in the manual.
ALL THE GUARDS must be in place
while operating the sander to ensure
safety.
MAKE SURE before making any
adjustments, the switch is in the “OFF”
position and the cord is un-plugged from
the power source.
NEVER sand more than one work piece
at a time on this sander.
DO NOT wear loose clothing and
jewelry while operating this sander.
KEEP YOUR WORK AREA CLEAN.
Cluttered areas and workbenches
increase the chance of accident.
NEVER LEAVE the sander unattended
while it is running.
KEEP CHILDREN AWAY. All visitors
should be kept at a safe distance from
the work area.
DO NOT force the sander. It will do the
job better and will be safer at the
operating rate for which it is designed.
ALWAYS wear a dust mask and safety
glasses while operating the sander. The
tiny dust particles produced by the
sander can cause serious health
problems.
ALWAYS inspect stock for staples, nails
knots or any other foreign material
before sanding.
ALWAYS operate the sander in a well-
ventilated area and use a dust collection
system for dust removal whenever
possible.
ALWAYS hold the work piece firmly
when sanding. When not using the
table, i.e. sanding free-hand, grip the
work piece with both hands.
NEVER STAND DIRECTLY inline with
the either in-feed or out-feed tables.
Stand on the side.
MAINTAIN AND SERVICE your sander
regularly as instructed in the user
manual.
MAKE SURE you have read and
understood all the safety instructions in
the manual and you are familiar with
your CX509 sander, before operating it.
If you fail to do so, serious injury could
occur.
WARNING!
The safety instructions given above can not be complete because the environment in
every shop is different. Always consider safety first as it applies to your individual
working conditions.
CX509 - 18" OPEN END DRUM SANDER
SPECIFIC SAFETY INSTRUCTIONS
To Next Page
Loading...
Need help?
General
